Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › OCCUPANT CLASSIFICATION ECU

OCCUPANT CLASSIFICATION ECU > INSTALLATION

for Preparation Click here



1. INSTALL OCCUPANT CLASSIFICATION ECU


    C165115
  1. Install the occupant classification ECU with the claw.

    NOTICE:
    1. If the occupant classification ECU has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the occupant classification ECU with a new one.
    2. When installing the occupant classification ECU, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

  1. Connect the 2 connectors.



2. INSTALL FRONT SEAT ASSEMBLY RH (for Manual Seat)

HINT:
Use the same procedure for the RH side and the LH side .



3. INSPECT FRONT SEAT SLIDE ADJUSTER LOCK (for Manual Seat)
  1. During sliding operation of the front seat, check that the left and right adjusters move together smoothly and lock simultaneously.
    If the seat adjusters do not lock simultaneously, loosen the bolts securing the seat to adjust the adjuster position.



4. INSTALL REAR SEAT TRACK COVER RH (for Manual Seat)

HINT:
Use the same procedure for the RH side and the LH side .



5. INSTALL FRONT INNER SEAT TRACK COVER RH (for Manual Seat)

HINT:
Use the same procedure for the RH side and the LH side .



6. INSTALL FRONT OUTER SEAT TRACK COVER RH (for Manual Seat)

HINT:
Use the same procedure for the RH side and the LH side .



7. INSTALL FRONT SEAT HEADREST ASSEMBLY RH (for Manual Seat)

HINT:
Use the same procedure for the RH side and the LH side .



8. INSTALL FRONT SEAT ASSEMBLY RH (for Power Seat)

HINT:
Use the same procedure for the RH side and the LH side .



9. INSTALL REAR INNER SEAT TRACK COVER RH (for Power Seat)

HINT:
Use the same procedure for the RH side and the LH side .



10. INSTALL REAR OUTER SEAT TRACK COVER RH (for Power Seat)

HINT:
Use the same procedure for the RH side and the LH side .



11. INSTALL FRONT INNER SEAT TRACK COVER RH (for Power Seat)

HINT:
Use the same procedure for the RH side and the LH side .



12. INSTALL FRONT OUTER SEAT TRACK COVER RH (for Power Seat)

HINT:
Use the same procedure for the RH side and the LH side .



13. INSTALL FRONT SEAT HEADREST ASSEMBLY RH (for Power Seat)

HINT:
Use the same procedure for the RH side and the LH side .



14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (for Manual Seat)

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



15. INSPECT FRONT SEAT ASSEMBLY (for Power Seat)
  1. Inspect the power seat operation.

  1. w/ Seat Heater System:
    Check the seat heater operation.

    1. Turn the ignition switch on (IG).

    2. Turn the seat heater switch on.

    3. Wait 5 minutes or more and confirm that the seat surface becomes warm.



16. INSPECT SRS WARNING LIGHT
  1. Inspect the SRS warning light (Click here).