Home › RESTRAINTS › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY

FRONT SEAT OUTER BELT ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


    B170909
  1. Engage the adjuster positioning hole with the claw and install the front shoulder belt anchor adjuster assembly with the 2 bolts.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }



2. INSTALL FRONT SEAT OUTER BELT ASSEMBLY


    B170906E01
  1. Temporarily install the front seat outer belt assembly with the 2 bolts.

  1. Fully tighten the bolt <A> first, then the bolt <B> to install the front seat outer belt assembly.

    Torque:
    Bolt <A>:
    7.5 N*m{ 77 kgf*cm , 66 in.*lbf }
    Bolt <B>:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }



    B170908
  1. Connect the connector and lock the locking button as shown in the illustration.

    NOTICE:
    Securely lock the locking button.



    B170905
  1. Connect the shoulder anchor of the front seat outer belt assembly with the nut.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }



3. INSTALL CENTER PILLAR GARNISH


    B173229
  1. Engage the 2 guides and the clip.

  1. Install the center pillar garnish LH with the clip and screw.



4. CONNECT FRONT SEAT OUTER BELT ASSEMBLY


    B170910
  1. Install the floor end of the front seat outer belt assembly with the bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

  1. Check if the ELR locks.

    NOTICE:
    The check should be performed with the outer belt assembly installed.


    1. With the belt assembly installed, check that the belt locks when it is pulled out quickly.



5. INSTALL LOWER CENTER PILLAR GARNISH


    B173231
  1. Engage the 2 claws and the 2 clips, and install the lower center pillar garnish LH.



6. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP


    B173233E01
  1. Align the alignment mark (red) on the weatherstrip with the protruding portion on the body indicated by the arrow in the illustration, and install the rear door opening trim weatherstrip LH.

    NOTICE:
    After installation, check that the corners fit correctly.



7. INSTALL REAR DOOR SCUFF PLATE


    B173228
  1. Engage the guide, 3 clips and 5 claws, and install the rear door scuff plate LH.



8. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP


    B173235E01
  1. Align the alignment mark (blue) on the weatherstrip with the protruding portion on the body indicated by the arrow in the illustration, and install the front door opening trim weatherstrip LH.

    NOTICE:
    After installation, check that the corners fit correctly.



9. INSTALL FRONT DOOR SCUFF PLATE


    B173224
  1. Engage the guide and the 8 claws, and install the front door scuff plate LH.



10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
Some systems need to be initialized after the cable is reconnected (Click here).



11. INSPECT SRS WARNING LIGHT
(Click here)