Home › RESTRAINTS › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY

FRONT SEAT OUTER BELT ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system (Click here).

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE FRONT DOOR SCUFF PLATE


    B173224
  1. Disengage the 8 claws and guide, and remove the front door scuff plate LH.



3. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP


4. REMOVE REAR DOOR SCUFF PLATE


    B173228
  1. Disengage the 5 claws, 3 clips and guide, and remove the rear door scuff plate LH.



5. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP


6. REMOVE LOWER CENTER PILLAR GARNISH


    B173230
  1. Disengage the 2 claws and 2 clips, and remove the lower center pillar garnish LH.



7. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY


    B170910
  1. Remove the bolt and disconnect the floor end of the front seat outer belt assembly.



8. REMOVE CENTER PILLAR GARNISH


    B173229
  1. Remove the screw and clip.

  1. Disengage the 2 guides and clip, and remove the center pillar garnish LH.



9. REMOVE FRONT SEAT OUTER BELT ASSEMBLY


    B170905
  1. Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.



    B170907
  1. Using a screwdriver, pull out the locking button in the direction shown by the arrow to release the lock, and disconnect the pretensioner connector as shown in the illustration.

    HINT:
    Tape the screwdriver tip before use.



    B170906
  1. Remove the 2 bolts and front seat outer belt assembly.



10. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


    B170909
  1. Remove the 2 bolts and front shoulder belt anchor adjuster assembly.