AUDIO AND VISUAL SYSTEM > Radio Broadcast cannot be Received or Poor Reception |
| 1.CHECK RADIO RECEIVER |
Check the radio's automatic station search function.
Check the radio's automatic station search function by activating it.
|
| ||||
| OK | ||
| ||
| 2.CHECK OPTIONAL COMPONENTS |
Check optional components (sun-shade film, telephone antenna, etc.).
Check if any optional components that may decrease reception capacity, such as sunshade film or a telephone antenna , are installed.
|
| ||||
| OK | ||
| ||
| 3.CHECK RADIO RECEIVER |
![]() |
Preparation for check
Remove the antenna plug from the radio receiver.
Check for noise
Turn the power switch on (ACC) with the radio receiver connector connected.
Turn the radio on and tune into AM mode.
Place a screwdriver, thin wire, or other metal object on the radio receiver's antenna jack and check that noise can be heard from the speaker.
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - ANTENNA AMPLIFIER) |
![]() |
Disconnect the radio receiver connector and the antenna amplifier connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E2-13 (ANT) - E7-1 (B) (*1) | Always | Below 1 Ω |
| E8-8 (ANT) - E7-1 (B) (*2) | Always | Below 1 Ω |
| E2-13 (ANT) - Body ground (*1) | Always | 10 kΩ or higher |
| E8-8 (ANT) - Body ground (*2) | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 5.INSPECT RADIO RECEIVER |
![]() |
Reconnect the radio receiver connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E7-1 (B) - Body ground | Power switch on (IG) Radio switch ON | 11 to 14 V |
|
| ||||
| OK | |
| 6.CHECK ANTENNA CORD |
Remove the antenna plug of the radio receiver and antenna.
Measure the resistance between the antenna and radio receiver to check for an open circuit in the antenna cord.
Measure the resistance between the antenna cord and body ground to check for a short circuit in the antenna cord.
| Result | Proceed to |
| OK | A |
| NG (for Glass Antenna Type) | B |
| NG (for Pole Antenna Type) | C |
|
| ||||
| OK | |
| 7.CHECK GLASS ANTENNA |
![]() |
Check for continuity of the antenna.
|
| ||||
| OK | |
| 8.REPLACE AMPLIFIER ANTENNA |
Replace the amplifier antenna and check if radio broadcasts can be received normally.
|
| ||||
| OK | ||
| ||