Home › ENGINE › 3MZ-FE ENGINE CONTROL SYSTEM › CAMSHAFT OIL CONTROL VALVE

CAMSHAFT OIL CONTROL VALVE > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT CAM TIMING OIL CONTROL VALVE ASSY RH
  1. Connect the Techstream to the DLC3.

  1. Put the engine in inspection mode (Click here).

  1. Turn the power switch on (IG) and turn the Techstream on.

  1. Warm up the engine.

  1. Enter the following menus: Powertrain / Engine / Active Test.

  1. Check the engine speed when the OCV (camshaft timing oil control valve) is operated using the Techstream.

    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Control the VVT Linear (Bank 1)
    Control the VVT (bank 1 intake side)
    Between -128 and 127%
    This valve added to present OCV control duty
    100%: Maximum advance
    -100%: Maximum retard
    Engine stalls or idles roughly when VVT actuator operated by 100%. Test is possible while idling.
    Control the VVT System (Bank 1)
    Turn on and off OCV
    (Oil control valve)
    ON/OFF
    1. Engine stalls or idles roughly when oil control valve turned on
    2. Normal engine running or idling when oil control valve off
    Control the VVT Linear (Bank 2)
    Control the VVT (bank 2 intake side)
    Between -128 and 127%
    Same as above
    Control the VVT System (Bank 2)
    Turn on and off OCV
    (Oil control valve)
    ON/OFF
    1. Engine stalls or idles roughly when oil control valve turned on
    2. Normal engine running or idling when oil control valve off