Home › ENGINE › 3MZ-FE ENGINE CONTROL SYSTEM › AIR FUEL RATIO SENSOR

AIR FUEL RATIO SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL AIR FUEL RATIO SENSOR (for Bank 2)
  1. Temporarily tighten the air fuel ratio sensor to the exhaust manifold sub-assembly LH.

    NOTICE:
    Do not damage the air fuel ratio sensor.



    A173499E01
  1. Using SST, fully tighten the air fuel ratio sensor to the exhaust manifold sub-assembly LH.

    SST
    09224-00010  

    Torque:
    44 N*m{ 449 kgf*cm , 33 ft.*lbf } for use without SST
    40 N*m{ 408 kgf*cm , 30 ft.*lbf } for use with SST

    HINT:
    1. Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
    2. Make sure that SST and the wrench are connected in a straight line.

  1. Connect the air fuel ratio sensor connector and clamp.



2. INSTALL AIR FUEL RATIO SENSOR (for Bank 1)
  1. Temporarily tighten the air fuel ratio sensor to the exhaust manifold sub-assembly RH.

    NOTICE:
    Do not damage the air fuel ratio sensor.



    A173501E01
  1. Using SST, fully tighten the air fuel ratio sensor to the exhaust manifold sub-assembly RH.

    SST
    09224-00010  

    Torque:
    44 N*m{ 449 kgf*cm , 33 ft.*lbf } for use without SST
    40 N*m{ 408 kgf*cm , 30 ft.*lbf } for use with SST

    HINT:
    1. Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
    2. Make sure that SST and the wrench are connected in a straight line.

  1. Connect the air fuel ratio sensor connector.



3. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY RH

HINT:
Click here.