Home › HYBRID SYSTEM ยท P310 › HYBRID TRANSMISSION / TRANSAXLE › HYBRID TRANSAXLE SYSTEM

HYBRID TRANSAXLE SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT OIL PRESSURE IN OIL PUMP

NOTICE:
Perform this inspection at normal operating oil temperature 50 to 80°C (122 to 176°F).

  1. Lift up the vehicle.



    C103082E01
  1. Remove the fluid pump cover plug and install SST.

    SST
    09992-00095   (09992-00112, 09992-00271)

  1. Enter 2WD inspection mode (Click here).

  1. Measure the oil pressure.

    Oil pressure:

    Engine Speed
    Oil Pressure
    900 rpm
    9.8 kPa (0.1 kgf/cm2, 1.4 psi) or more

    NOTICE:
    Be sure to cancel the inspection mode immediately after the oil pressure check is completed (Click here).



    C103083
  1. Install a new O-ring and fluid pump cover plug.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }