Home › BRAKE › BRAKE CONTROL › ELECTRONICALLY CONTROLLED BRAKE SYSTEM

DTC    C1259/58    HV System Regenerative Malfunction

DTC    C1310/51    Malfunction in HV system

for Preparation Click here


DESCRIPTION

The skid control ECU communicates with the hybrid vehicle control ECU and controls braking force according to the motor's regenerative force.
The skid control ECU sends enhanced VSC signals to the hybrid vehicle control ECU and inputs operating signals from the hybrid vehicle control ECU.
The skid control ECU uses CAN communication for communication with the hybrid vehicle control ECU. If a communication malfunction is memorized, the skid control ECU prohibits enhanced VSC operation and a part of electronically controlled brake system control by fail safe function.
DTC C1259/58 is stored if the power switch on (IG) with the HV battery service plug disconnected.

DTC Code
INF Code
DTC Detection Condition
Trouble Area
C1259/58
150
The regeneration malfunction signal is input for at least 0.02 seconds when IG2 terminal voltage is 9.5 V or more for at least 2 seconds and communication with hybrid vehicle control ECU is valid.
Hybrid control system
C1310/51
156
The traction control prohibition signal is received for at least 0.07 seconds when IG2 terminal voltage is 10.5 V or more for at least 1.5 seconds and communication with hybrid vehicle control ECU is valid.
Hybrid control system

HINT:
This DTC will be output from the skid control ECU when the hybrid vehicle control ECU sends a malfunction signal to the skid control ECU.


INSPECTION PROCEDURE

1.CHECK HYBRID CONTROL SYSTEM
  1. Check if the hybrid control system DTC is output (Click here).

    Result:

    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
INSPECT HYBRID CONTROL SYSTEM (Click here)
A

REPLACE HYBRID VEHICLE CONTROL ECU (Click here)