Home › HYBRID SYSTEM ยท P310 › HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P2601-778    Coolant Pump Control Circuit Range / Performance

for Preparation Click here


DESCRIPTION

HINT:
Although the DTC title refers to "coolant pump", this DTC is related to the oil pump control circuit.

Refer to the description for DTC P2601-777 .

DTC No.
INF No.
DTC Detection Condition
Trouble Area
P2601
778
  1. Ambient temperature is 41°F (5°C) or more
  2. Duty output from oil pump with motor assembly is between 65 and 75%
  3. Oil pump with motor assembly does not start
  1. Ambient temperature sensor
  2. Fluid piping
  3. Oil pump with motor assembly

INSPECTION PROCEDURE

NOTICE:
  1. When troubleshooting the oil pump with motor assembly, check for the following conditions:
    1. ATF temperature inside the oil cooler is 41°F (5°C) or more.
    2. The ambient temperature sensor value is 41°F (5°C) or more.

1.CHECK AMBIENT TEMPERATURE SENSOR

HINT:
The ambient temperature sensor value is used to detect DTC P2601-778. Check that the ambient temperature sensor operates normally, because P2601-778 may be mistakenly detected due to a malfunction in the ambient temperature sensor.

  1. Following the troubleshooting procedures for the ambient temperature sensor, check that the ambient temperature sensor operates normally.



NG
GO TO AMBIENT TEMPERATURE SENSOR INSPECTION (Click here)
OK


2.CHECK FLUID PIPES
  1. Check that there is no clogging in the pipes among the oil pump with motor assembly, oil cooler, and hybrid vehicle transaxle.



NG
REPAIR OR REPLACE FLUID PIPES
OK


3.CHECK OPERATION OF OIL PUMP WITH MOTOR ASSEMBLY
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Select the following menu items: Powertrain / Hybrid Control / Active Test / Inspection Mode - 2WD Inspection.

  1. Turn the power switch on (READY) to enter oil pump forced activation mode.

  1. Check if DTCs are output.

    Result:
    Result
    Proceed to
    P2061-778 is not output.
    A
    P2061-778 is output.
    B

    HINT:
    If the vehicle is driven at high loads when it is cold, the temperature of the motor generator might increase until it reaches the operating temperature of the oil pump with motor assembly. This temperature increase of the motor generator could happen before the temperature of the ATF goes up. When this DTC is stored as a result of the above conditions, it is not necessary to replace the oil pump with motor assembly as it is not malfunctioning. However, the DTC is stored because the detection conditions of the DTC have been met.
    When ATF whose low temperature viscosity is higher than ATF-WS is used, DTC P2601-778 might be output.



B
REPLACE OIL PUMP WITH MOTOR ASSEMBLY (Click here)
A

COMPLETED