Home › BODY ELECTRICAL › OTHER SYSTEM › CLOCK SYSTEM

CLOCK SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT CLOCK ASSEMBLY


    E146936E01
  1. Disconnect the E11 connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E11-1 (IG) - Body ground
    Power switch off
    Below 1 V
    Power switch on (READY)
    11 to 14 V
    E11-6 (+B) - Body ground
    Always
    11 to 14 V

    HINT:
    If the value is not as specified, repair or replace the wire harness or connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E11-5 (GND) - Body ground
    Always
    Below 1 Ω

    HINT:
    If the value is not as specified, repair or replace the wire harness or connector.



2. INSPECT CLOCK ASSEMBLY


    E146939
  1. Turn the power switch off.

  1. Press the "DISP" switch and hold it down.

  1. Turn the power switch on (READY).

    OK:
    All the dots in the multi-information display come on.

    HINT:
    This test is also available on "Active Test" (Click here).

  1. Turn the power switch off to finish this test mode.

    HINT:
    If the result is not as specified, replace the clock assembly .