Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT SPEEDOMETER
  1. Check the operation.

    1. Using a speedometer tester (calibrated chassis dynamometer), check the speedometer indication according to the table below.

      Reference: mph (for U.S.A.) 
      Chassis Dynamometer Indication
      Acceptable Range
      20 mph
      20.0 to 23.0 mph
      40 mph
      40.0 to 43.5 mph
      60 mph
      60.0 to 64.0 mph
      80 mph
      80.0 to 84.5 mph
      100 mph
      100.0 to 105.0 mph
      120 mph
      120.0 to 125.5 mph
      140 mph
      140.0 to 146.0 mph

      Reference: km/h (for Canada) 
      Chassis Dynamometer Indication
      Acceptable range
      Data in ( ) is for reference
      20 km/h
      (17.5 to 21.5 km/h)
      40 km/h
      38.0 to 42.0 km/h
      60 km/h
      58.0 to 63.0 km/h
      80 km/h
      78.0 to 84.0 km/h
      100 km/h
      98.5 to 104.5 km/h
      120 km/h
      119.0 to 125.0 km/h
      140 km/h
      139.0 to 146.0 km/h
      160 km/h
      159.0 to 167.0 km/h
      180 km/h
      179.0 to 188.0 km/h
      200 km/h
      199.0 to 209.0 km/h
      220 km/h
      219.0 to 230.0 km/h
      240 km/h
      239.0 to 251.0 km/h

      NOTICE:
      Tire wear as well as over or under inflation will cause errors.

    2. Check the deviation from the acceptable range of the speedometer indication.

      Reference:
      Less than 0.5 km/h (0.3 mph)

      HINT:
      If the indication is not as specified, go to problem symptoms table (Click here).



2. INSPECT MULTI-INFORMATION DISPLAY


    E146939
  1. Power switch off.

  1. Press the "DISP" button and hold it down.

  1. Power switch on (READY).

    OK:
    All the dots in the multi-information display come on.

    HINT:
    This test is also available on "Active Test" (Click here).

  1. Power switch off to finish this test mode.

    HINT:
    If the result is not as specified, replace the clock assembly .