Home › HYBRID SYSTEM ยท P310 › HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P0617-142    Starter Relay Circuit High

for Preparation Click here


DESCRIPTION


DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0617
142
An ST signal from the hybrid vehicle control ECU is present when the power switch is off.
  1. Wire harness or connector
  2. Hybrid vehicle control ECU
  3. Instrument panel junction block (Main body ECU)

WIRING DIAGRAM


A165972E06


INSPECTION PROCEDURE

1.CHECK CONNECTOR CONNECTION CONDITION (HYBRID VEHICLE CONTROL ECU CONNECTOR)


    A174883E01
  1. Check the connections of the hybrid vehicle control ECU connectors.

    OK:
    The connectors are connected securely and there are no contact problems.



NG
CONNECT SECURELY
OK


2.CHECK CONNECTOR CONNECTION CONDITION (MAIN BODY ECU CONNECTOR)


    B138004E18
  1. Check the connections of the main body ECU connectors.

    OK:
    The connectors are connected securely and there are no contact problems.



NG
CONNECT SECURELY
OK


3.CHECK HARNESS AND CONNECTOR (ST2 TERMINAL VOLTAGE)
  1. Turn the power switch off.



    A173947E04
  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage :
    Tester Connection
    Switch Condition
    Specified Condition
    D35-20 (ST2) - Body ground
    Power switch off
    Below 1 V



NG
Go to step 4
OK

REPLACE HYBRID VEHICLE CONTROL ECU (Click here)  

4.CHECK HARNESS AND CONNECTOR (HYBRID VEHICLE CONTROL ECU - MAIN BODY ECU)


    A173960E01
  1. Disconnect connector D10 from the instrument panel junction block (main body ECU).



    A173947E05
  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage :
    Tester Connection
    Switch Condition
    Specified Condition
    D35-20 (ST2) - Body ground
    Power switch off
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE INSTRUMENT PANEL JUNCTION BLOCK