Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > Hybrid Vehicle Control ECU Communication Stop Mode

for Preparation Click here


DESCRIPTION


Detection Item
Symptom
Trouble Area
HYBRID VEHICLE CONTROL ECU COMMUNICATION STOP MODE
  1. HV Control is not displayed on the "CAN Bus Check" screen of Techstream
  2. "Hybrid Vehicle Control ECU COMMUNICATION STOP MODE" in the "DTC COMBINATION TABLE"
  1. Power source circuit of the Hybrid Vehicle control ECU
  2. Hybrid Vehicle control ECU

WIRING DIAGRAM


C113214E07


INSPECTION PROCEDURE

NOTICE:
  1. Turn the power switch off before measuring the resistances of the CAN main wire and the CAN branch wire.
  2. After the power switch is turned off, check that the key reminder warning system and light reminder warning system are not in operation.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the power switch, any other switches or the doors. If the doors need to be opened in order to check the connectors, open the doors and leave them open.

HINT:
  1. Operating the power switch, any other switches, or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
  2. Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below will help determine the cause of the malfunction.

1.CHECK CAN BUS WIRE (HYBRID VEHICLE CONTROL ECU MAIN WIRE)
  1. Turn the power switch off.

  1. Disconnect the hybrid vehicle control ECU connector (D36).



    C176073E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    D36-25 (CANH) - D36-33 (CANL)
    Power switch off
    108 to 132 Ω



NG
REPAIR OR REPLACE CAN BUS MAIN WIRE (HYBRID VEHICLE CONTROL ECU MAIN WIRE)
OK


2.CHECK WIRE HARNESS (+B1, +B2, IGSW, MREL, E1)


    A103658E70
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    B3-5 (E1) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D35-9 (IGSW) - Body ground
    Power switch on
    11 to 14 V
    A43-1 (+B2) - Body ground
    Power switch on
    11 to 14 V
    A43-2 (+B1) - Body ground
    Power switch on
    11 to 14 V
    A43-12 (MREL) - Body ground
    Power switch on
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE HYBRID VEHICLE CONTROL ECU (Click here)