Home › HYBRID SYSTEM ยท P310 › HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P0630-804    VIN not Programmed or Mismatch-ECM / PCM

for Preparation Click here


DESCRIPTION

DTC P0630 is set if the Vehicle Identification Number (VIN) is not stored in the hybrid vehicle control ECU or the input VIN is not accurate. Input the VIN with the Techstream (Click here).

DTC No.
INF No.
DTC Detection Condition
Trouble Area
P0630
804
  1. VIN not stored in hybrid vehicle control ECU
  2. Input VIN in hybrid vehicle control ECU not accurate
Hybrid vehicle control ECU

INSPECTION PROCEDURE

1.CHECK DTC OUTPUT (HV)

NOTICE:
If P0630 is set, the VIN must be input to the hybrid vehicle control ECU using the Techstream. However, all DTCs will be cleared automatically by the Techstream when inputting the VIN. If DTCs other than P0630-804 are set, check them first.


NEXT


2.INPUT VIN WITH TECHSTREAM
  1. Input the VIN with the Techstream. (Click here)

    NOTICE:
    Be sure to check the auxiliary battery voltage before performing VIN writing because VIN writing cannot be performed if the auxiliary battery voltage is below 10 V.


NEXT


3.CHECK DTC OUTPUT (HV)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Select the following menu items: Powertrain / Hybrid Control / Trouble Codes.

  1. Read output DTC.

    OK:
    DTC P0630-804 is not output.



NG
REPLACE HYBRID VEHICLE CONTROL ECU (Click here)
OK

COMPLETED