Home › HYBRID SYSTEM ยท P310 › HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P0A1B-192    Drive Motor "A" Control Module

DTC    P0A1B-193    Drive Motor "A" Control Module

DTC    P0A1B-196    Drive Motor "A" Control Module

DTC    P0A1B-198    Drive Motor "A" Control Module

DTC    P0A1B-661    Drive Motor "A" Control Module

DTC    P0A1B-662    Drive Motor "A" Control Module

DTC    P0A1B-781    Drive Motor "A" Control Module

DTC    P0A1B-786    Drive Motor "A" Control Module

for Preparation Click here


DESCRIPTION

The MG ECU located in the inverter with converter assembly monitors its internal operation and it will set DTCs when it detects malfunctions. If any of the following DTCs are output, replace the inverter with converter assembly.

HINT:
The term "drive motor A" indicates MG2.


DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0A1B
192
A/D error
Inverter with converter assembly (MG ECU)
193
ROM-RAM error
196
Run pulse error
198
R/D converter NM stop error
661
Communication error (from MG2 to MG1)
662
Communication error (from MG2 to MGR)
781
Primary check error
786
ALU error

MONITOR DESCRIPTION

The MG ECU performs many diagnostic tests to verify proper operation of internal ECU systems. In one of those diagnostics, the MG ECU checks the result of the motor CPU self-test. If the MG ECU detects a "Fail" from the motor CPU self-test, it will conclude that there is an internal malfunction in the motor CPU. The hybrid vehicle control ECU will illuminate the MIL and set a DTC.

MONITOR STRATEGY


Related DTCs
P0A1B (INF 192): A/D malfunction (2MG CPU)
P0A1B (INF 193): RAM and ROM destruction
P0A1B (INF 196): Motor RUN pulse malfunction
P0A1B (INF 198): RD Converter NM Signal Stop abnormality
P0A1B (INF 661): 2MG CPU communication malfunction (2MG CPU to 1MG CPU)
P0A1B (INF 662): 2MG CPU communication malfunction (2MG CPU to 3MG CPU)
P0A1B (INF 781): Primary check malfunction
P0A1B (INF 786): MG CPU ALU malfunction
Required sensors / components
Motor Generator control ECU (MG ECU)
Frequency of operation
Continuous
Duration
TMC's intellectual property
MIL operation
1 driving cycle
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


The monitor will run whenever the DTCs listed are not present
TMC's intellectual property
Other conditions belong to TMC's intellectual property
-

TYPICAL MALFUNCTION THRESHOLDS


Motor Generator control ECU (MG ECU)
Internal error

COMPONENT OPERATING RANGE


Motor Generator control ECU (MG ECU)
DTC P0A1B (INF 192/193/196/198/661/662/781/786) is not detected

INSPECTION PROCEDURE

1.REPLACE INVERTER WITH CONVERTER ASSEMBLY
  1. Replace the inverter with converter assembly (Click here).


NEXT

COMPLETED