Home › HYBRID SYSTEM ยท P310 › HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P0A1D-717    Hybrid Powertrain Control Module

DTC    P0A1D-718    Hybrid Powertrain Control Module

DTC    P0A1D-815    Hybrid Powertrain Control Module

for Preparation Click here


DESCRIPTION

The hybrid vehicle control ECU monitors internal operation, it will set DTCs and perform fail-safe control when it detects the following malfunctions. If any of following DTCs are output, replace the hybrid vehicle control ECU.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0A1D
717
ECU internal error
Hybrid vehicle control ECU
718
ECU internal error
815
ECU internal error

MONITOR DESCRIPTION

The hybrid vehicle control ECU performs diagnostic monitoring to verify proper operation of vehicle systems. One of these monitors the rationality of internal analog (signal) to digital conversions. The hybrid vehicle control ECU monitors the internal A/D (Analog/Digital Converter) value. If there is an A/D malfunction, the hybrid vehicle control ECU will illuminate the MIL and set a DTC.

MONITOR STRATEGY


Related DTCs
P0A1D (INF 717/718/815): IC malfunction
Required sensors / components
Hybrid vehicle control ECU
Frequency of operation
Continuous
Duration
TMC's intellectual property
MIL operation
1 driving cycle
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


The monitor will run whenever the DTCs listed are not present
TMC's intellectual property
Other conditions belong to TMC's intellectual property
-

TYPICAL MALFUNCTION THRESHOLDS


TMC's intellectual property
-

COMPONENT OPERATING RANGE


Hybrid vehicle control ECU
DTC P0A1D (INF 717/718/815) is not detected

INSPECTION PROCEDURE

1.REPLACE HYBRID VEHICLE CONTROL ECU
  1. Replace the hybrid vehicle control ECU (Click here).


NEXT

COMPLETED