Home › HYBRID SYSTEM ยท P310 › HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P0A1D-789    Hybrid Powertrain Control Module

for Preparation Click here


DESCRIPTION

The hybrid vehicle control ECU monitors internal operation, it will set a DTC and perform fail-safe control when it detects the following malfunction. If following DTC is output, replace the hybrid vehicle control ECU.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0A1D
789
ECU internal error
Hybrid vehicle control ECU

MONITOR DESCRIPTION

The hybrid vehicle control ECU performs diagnostic monitoring to verify proper operation of internal ECU systems. In this diagnostics monitor, the hybrid vehicle control ECU checks the communication bus off count and the message register of the CAN (Controller Area Network) controller. If the hybrid vehicle control ECU detects an error in the communication bus off count or message register, it will conclude that there is a malfunction in the hybrid vehicle control ECU. The hybrid vehicle control ECU illuminates the MIL and sets a DTC.

MONITOR STRATEGY


Related DTCs
P0A1D (INF 789): CAN communication malfunction
Required sensors / components
Hybrid vehicle control ECU
Frequency of operation
Continuous
Duration
TMC's intellectual property
MIL operation
1 driving cycle
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


The monitor will run whenever the DTCs listed are not present
TMC's intellectual property
Other conditions belong to TMC's intellectual property
-

TYPICAL MALFUNCTION THRESHOLDS


TMC's intellectual property
-

COMPONENT OPERATING RANGE


Hybrid vehicle control ECU
DTC P0A1D (INF 789) is not detected

INSPECTION PROCEDURE

1.REPLACE HYBRID VEHICLE CONTROL ECU
  1. Replace the hybrid vehicle control ECU (Click here).


NEXT

COMPLETED