Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > TC and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

Connecting terminals TC and CG of the DLC3 makes the tire pressure warning light blink to output DTCs.

WIRING DIAGRAM


C171017E01

HINT:
When various warning lights continue blinking, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in each ECU is suspected.


INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU, read the transmitter IDs stored in the old ECU using the Techstream and write them down before removal.
  2. It is necessary to perform registration (Click here) of the transmitter IDs into the tire pressure warning ECU if the ECU has been replaced.

1.CHECK HARNESS AND CONNECTOR (DLC3 - ECM AND BODY GROUND)


    C178312E01
  1. Disconnect the D35 ECU connector.



    C166029E08
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D47-13 (TC) - D35-3 (TC)
    Always
    Below 1 Ω
    D47-13 (TC) or D35-3 (TC) - Body ground
    Always
    10 kΩ or higher
    D47-4 (CG) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR OR EACH ECU
OK


2.INSPECT DLC3 (TC VOLTAGE)


    C166029E08
  1. Connect the D35 ECM connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D47-13 (TC) - D47-4 (CG)
    Power switch on (IG)
    11 to 14 V



NG
REPLACE HYBRID VEHICLE CONTROL ECU
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)