HYBRID BATTERY SYSTEM > DIAGNOSIS SYSTEM |
| DESCRIPTION |
The hybrid vehicle control ECU has a self-diagnosis system. If the computer, HV battery system, or a component is not working properly, the ECU records the conditions that relate to the fault. The ECU also illuminates the master warning light in the combination meter and provides other appropriate messages on the multi-information display, such as the HV system warning message, the HV battery warning message, or the discharge warning message.

![]() |
| 2 TRIP DETECTION LOGIC |
When a malfunction is first detected, the malfunction is temporarily stored in the hybrid vehicle control ECU memory (1st trip). If the same malfunction is detected during the next drive cycle, the MIL is illuminated (2nd trip).
| FREEZE FRAME DATA |
The hybrid vehicle control ECU records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was running or stopped, whether the engine was warmed up or not, as well as other data recorded at the time of a malfunction.
| AUXILIARY BATTERY VOLTAGE |
Measure the voltage of the auxiliary battery.
| MIL (Malfunction Indicator Lamp) |
The MIL is illuminated when the power switch is first turned on (IG), before the READY light comes on.
When the READY light comes on, the MIL should turn off. If the MIL remains illuminated, the diagnosis system has detected a malfunction or abnormality in the system.