Home › HYBRID SYSTEM ยท P310 › HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P3004-803    Power Cable Malfunction

for Preparation Click here


DESCRIPTION

The hybrid vehicle control ECU monitors the high-voltage wiring between the HV battery and inverter with converter assembly and detects the following malfunction.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P3004
803
EV battery fuse is blown out, service plug grip is disconnected, or SMR2 or SMR3 is open
HV relay assembly

INSPECTION PROCEDURE

CAUTION:
  1. Before inspecting the high-voltage system or disconnecting the low voltage connector of the inverter with converter assembly, take safety precautions such as wearing insulated gloves and removing the service plug grip to prevent electrical shocks. After removing the service plug grip, put it in your pocket to prevent other technicians from accidentally reconnecting it while you are working on the high-voltage system.
  2. After disconnecting the service plug grip, wait for at least 5 minutes before touching any of the high-voltage connectors or terminals. After waiting for 5 minutes, check the voltage at the terminals in the inspection point in the inverter with converter assembly. The voltage should be 0 V before beginning work.

HINT:
Waiting for at least 5 minutes is required to discharge the high-voltage capacitor inside the inverter with converter assembly.

1.CHECK DTC OUTPUT (HV)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Select the following menu items: Powertrain / Hybrid Control / Trouble Codes.

  1. Check if DTCs are output.

    Result:
    Result
    Proceed to
    P3004-803 only is output.
    A
    Any of the following DTCs are also output.
    B


    DTC No.
    Relevant Part
    P0ADC-226
    Hybrid Battery Positive Contactor Control Circuit High
    P0ADB-227
    Hybrid Battery Positive Contactor Control Circuit Low
    P0ADF-229
    Hybrid Battery Negative Contactor Control Circuit Low
    P0AE0-228
    Hybrid Battery Negative Contactor Control Circuit High



B
GO TO DTC CHART (Click here)
A


2.CLEAR DTC
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Select the following menu items: Powertrain / Hybrid Control / Trouble Codes.

  1. Clear DTCs and freeze frame data.


NEXT


3.CHECK DTC OUTPUT (HV)
  1. Turn the power switch on (Ready).

  1. Allow the vehicle to creep back and forth.

  1. Select the following menu items: Powertrain / Hybrid Control / Trouble Codes.

  1. Check if DTCs are output.

    Result:
    Output DTC
    Proceed to
    DTC P3004-803 is output.
    A
    DTC P3004-131 is output.
    B



B
GO TO DTC CHART (Click here)
A

REPLACE HV RELAY ASSEMBLY (Click here)