POWER STEERING SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK STEERING EFFORT |
Stop the vehicle on a level, paved surface and turn the wheels straight ahead.
Disconnect the negative (-) battery cable from the battery.
Remove the steering pad (Click here).
Connect the negative (-) battery cable to the battery.
Using a torque wrench, check if the steering wheel set nut is properly tightened.
Start the engine and run it at idle.
![]() |
Turn the steering wheel 90° to the right and check the steering effort (torque) while turning. Check in the opposite direction using the same method.
Align the front wheels straight ahead.
Disconnect the negative (-) battery cable from the battery.
Torque the steering wheel set nut.
Install the steering pad (Click here).
Connect the negative (-) battery cable to the battery.
Clear the DTCs (Click here).
Inspect the SRS warning light (Click here).