Home › ENGINE › 3MZ-FE STARTING › SMART KEY SYSTEM

DTC    B2275    STSW Monitor Malfunction

for Preparation Click here


DESCRIPTION

This DTC is output when there is an open, short, or any other problem in the hybrid control system start request output circuit inside the main body ECU (instrument panel junction block) or in the external circuit.

HINT:
When the main body ECU is replaced with a new one and the negative (-) battery terminal is connected, the power source mode becomes the IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
After the main body ECU (instrument panel junction block) is replaced, perform the registration procedures for the engine immobiliser system (Click here).


DTC No.
DTC Detection Condition
Trouble Area
B2275
STSW output circuit (hybrid control system start request signal circuit) inside main body ECU (instrument panel junction block) or other related circuit is malfunctioning
  1. Main body ECU (instrument panel junction block)
  2. Hybrid vehicle control ECU
  3. Wire harness or connector

WIRING DIAGRAM


B176786E08


INSPECTION PROCEDURE

1.CHECK DTC OUTPUT
  1. Delete the DTCs (Click here).

    HINT:
    After all DTCs are cleared, turn the power switch on (IG) and depress the brake pedal. After 15 seconds have elapsed, check if the trouble occurs again.

  1. Check for DTCs again.

    OK:
    No DTC is output.



NG
Go to step 2
OK

USE SYMPTOM METHOD TO CHECK (Click here)  

2.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - HYBRID VEHICLE CONTROL ECU)


  1. Disconnect the D10 ECU connector.


    B184068E01

  1. Disconnect the D35 hybrid vehicle control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D10-4 (STSW) - D35-20 (ST2)
    Always
    Below 1 Ω
    D10-4 (STSW) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT MAIN BODY ECU


    B138004E18
  1. Reconnect the D10 connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D10-4 (STSW) - Body ground
    Brake pedal depressed, Power switch hold on (ST)
    Output voltage at terminal AM1 or AM2 is -2 V or more.



NG
REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)
OK

REPLACE HYBRID VEHICLE CONTROL ECU (Click here)