Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › AIRBAG SYSTEM

DTC    B1635/24    Front Passenger Side Rear Airbag Sensor Malfunction

for Preparation Click here


DESCRIPTION

The rear airbag sensor RH circuit consists of the center airbag sensor assembly, rear airbag sensor RH, and side airbag sensor RH.
The side airbag sensor RH and rear airbag sensor RH detect impacts to the vehicle and send signals to the center airbag sensor assembly to determine if the airbag should be deployed.
DTC B1635/24 is recorded when a malfunction is detected in the rear airbag sensor RH.

DTC No.
DTC Detection Condition
Trouble Area
B1635/24
  1. Rear airbag sensor RH malfunction
  2. Center airbag sensor assembly malfunction
  1. Rear airbag sensor RH
  2. Center airbag sensor assembly

WIRING DIAGRAM


C165789E12


INSPECTION PROCEDURE

1.CHECK REAR AIRBAG SENSOR RH


    C114844E06
  1. Turn the power switch off.

  1. Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.

  1. Interchange the rear airbag sensor RH with LH and connect the connectors to them.

  1. Connect the negative (-) terminal cable to the battery.

  1. Turn the power switch on (IG), and wait for at least 60 seconds.

  1. Clear the DTCs stored in the memory (Click here).

  1. Turn the power switch off.

  1. Turn the power switch on (IG), and wait for at least 60 seconds.

  1. Check for DTCs (Click here).

    Result:
    Result
    Proceed to
    DTC B1630/23 and B1635/24 are not output
    A
    DTC B1635/24 is output
    B
    DTC B1630/23 is output
    C

    HINT:
    Codes other than DTC B1630/23 and B1635/24 may be output at this time, but they are not related to this check.



B
REPLACE CENTER AIRBAG SENSOR ASSEMBLY (Click here)

C
REPLACE REAR AIRBAG SENSOR RH (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)