Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM (w/ Navigation System)

REAR VIEW MONITOR SYSTEM (w/ Navigation System) > Reverse Signal Circuit

for Preparation Click here


DESCRIPTION

The navigation receiver assembly receives a reverse signal from the BK/UP LP relay.

WIRING DIAGRAM


E153748E02


INSPECTION PROCEDURE

1.CHECK BACK-UP LIGHT
  1. Move the shift lever to the R position and check if the back-up lights come on.

    OK:
    The back-up lights come on.



NG
GO TO LIGHTING SYSTEM (Click here)
OK


2.INSPECT NAVIGATION RECEIVER ASSEMBLY


    E141022E07
  1. Disconnect navigation receiver assembly connector E5.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E5-5 (REV) - Body ground
    Power switch on (IG)
    Shift lever R position
    10 to 14 V
    E5-5 (REV) - Body ground
    Power switch on (IG)
    Shift lever any position except R
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)