CAN COMMUNICATION SYSTEM > Open in One Side of CAN Branch Line |
| Symptom | Trouble Area |
| 2 or more ECUs and/or sensors repeatedly appear and disappear on the Techstream "CAN Bus Check" screen. | One side of the CAN branch wire is open
|
| 1.CHECK FOR OPEN IN ONE SIDE OF CAN NO. 1 BUS BRANCH WIRE |
Confirm the systems (ECUs and sensors), which use CAN communication, equipped on the vehicle. (Click here)
Using the Techstream, select and perform "CAN Bus Check". (Click here)
Observe the screen for approximately 1 minute to check the ECUs and sensors that are not displayed on the screen and also those that repeatedly appear and disappear on the screen.
Check that the ECUs and sensors, which are connected to the ECUs or sensors that are not displayed on the screen.
Check that the ECUs and sensors, which repeatedly appeared and disappeared from the "CAN Bus Check" screen, are constantly displayed.
| NEXT | ||
| ||