Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Reverse Signal Circuit

for Preparation Click here


DESCRIPTION

The navigation receiver assembly receives a reverse signal from the BK/UP LP relay and information about the GPS antenna, and then adjusts the vehicle position on the navigation display.

WIRING DIAGRAM


E153748E01


INSPECTION PROCEDURE

1.CHECK BACK-UP LIGHT
  1. Move the shift lever to the R position and check if the back-up lights come on.

    OK:
    The back-up lights come on.



NG
GO TO LIGHTING SYSTEM (Click here)
OK


2.INSPECT NAVIGATION RECEIVER ASSEMBLY


    E141022E05
  1. Disconnect navigation receiver assembly connector E5.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E5-5 (REV) - Body ground
    Power switch on (IG)
    Shift lever R position
    11 to 14 V
    E5-5 (REV) - Body ground
    Power switch on (IG)
    Shift lever any position except R
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)