Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

DTC    U0100    Lost Communication with ECM / PCM "A"

for Preparation Click here


DESCRIPTION

The combination meter assembly communicates with the hybrid vehicle control ECU via the CAN communication lines (CAN No. 1 Bus).

DTC No.
DTC Detection Condition
Trouble Area
U0100
When either of following condition is detected:
  1. Vehicle speed 5 km/h (3.1 mph) or more and IG voltage 10.5 V or more
  2. No communication with hybrid vehicle control ECU continues for 3 seconds or more (No communication to hybrid vehicle control ECU and skid control ECU continues for 60 seconds or more)
  1. CAN communication system
  2. Hybrid Vehicle Control ECU

WIRING DIAGRAM


E143765E08


INSPECTION PROCEDURE

1.CONFIRM DTC OUTPUT
  1. Connect Techstream to the DLC3.

  1. Power switch on (IG).

  1. Turn the tester on.

  1. Clear the stored DTCs by selecting the following menu items on the tester: Body Electrical / Trouble Codes.

  1. Drive the vehicle at more than 5 km/h (3.1 mph) for at least 60 seconds.

  1. Stop the vehicle.

  1. Check for DTCs (Click here).

    Result:
    Result
    Proceed to
    DTC is output.
    A
    DTC is not output.
    B

    HINT:
    If the CAN communication system DTC U100 and another DTC are output at the same time, perform troubleshooting for the CAN communication system DTC U0100 first.



B
USE SIMULATION METHOD TO CHECK (Click here)
A

GO TO CAN COMMUNICATION SYSTEM (Click here)