Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

DTC    U0129    Lost Communication with Skid Control ECU

for Preparation Click here


DESCRIPTION

The combination meter assembly communicates with the skid control ECU via the CAN communication system (CAN No. 1 Bus).

DTC No.
DTC Detection Condition
Trouble Area
U0129
When either of following condition is detected:
  1. 15 seconds have elapsed since the hybrid system started and IG voltage 10.5 V or more
  2. No communication with skid control ECU continues for 3 seconds or more (No communication with hybrid vehicle control ECU and skid control ECU continues for 60 seconds or more)
  1. Skid control ECU
  2. CAN communication system

WIRING DIAGRAM


E143765E07


INSPECTION PROCEDURE

1.CONFIRM DTC OUTPUT
  1. Connect Techstream to the DLC3.

  1. Power switch on (READY).

  1. Turn the tester on.

  1. Clear the stored DTCs by selecting the following menu items on the tester: Body Electrical / Trouble Codes.

  1. Drive the vehicle at more than 5 km/h (3.1 mph) for at least 60 seconds.

  1. Stop the vehicle.

  1. Check for DTCs (Click here).

    Result:
    Result
    Proceed to
    DTC is output.
    A
    DTC is not output.
    B

    HINT:
    If the CAN communication system DTC U129 and another DTC are output at the same time, perform troubleshooting for the CAN communication system DTC U0129 first.



B
USE SIMULATION METHOD TO CHECK (Click here)
A

GO TO CAN COMMUNICATION SYSTEM (Click here)