Home › ENGINE › 3MZ-FE ENGINE CONTROL SYSTEM › SFI SYSTEM

DTC    P0657    Actuator Supply Voltage Circuit / Open

for Preparation Click here


DESCRIPTION

The ECM (included in the hybrid vehicle control ECU) monitors the output voltage to the throttle actuator. This self-check ensures that the ECM is functioning properly. The output voltage is usually 0 V when the power switch is turned off. If the output voltage is higher than 7 V when the power switch is turned off, the ECM will illuminate the MIL and set a DTC when the power switch on (IG).

DTC
DTC Detection Condition
Trouble Area
P0657
Throttle actuator power supply error
(1 trip detection logic)
Hybrid vehicle control ECU

MONITOR STRATEGY


Related DTC
P0657: ETCS power supply
Required sensors/Components (Main)
Hybrid vehicle control ECU
Required sensors/Components (Related)
Throttle actuator
Frequency of Operation
Once per driving cycle
Duration
Within 1 second
MIL Operation
Immediate
Sequence of Operation
None

TYPICAL ENABLING CONDITIONS


Monitor runs whenever following DTCs are not present
None
Power switch
From ON to OFF

TYPICAL MALFUNCTION THRESHOLDS


Throttle actuator power supply
7 V or more

INSPECTION PROCEDURE

1.CHECK WHETHER DTC OUTPUT RECURS (DTC P0657)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG) and turn the Techstream on.

  1. Clear the DTCs (Click here).

  1. Turn the power switch off and turn the Techstream off.

  1. Disconnect the auxiliary battery negative terminal and wait for 1 minute.

  1. Connect the auxiliary battery negative terminal.

  1. Turn power switch on (IG) for 10 seconds.

  1. Turn the power switch off.

  1. Turn the power switch on (IG) and turn the Techstream on.

  1. Select the following menu items: Powertrain / Engine and ECT / Trouble Codes.

  1. Read the DTCs.

    Result:
    Display (DTC output)
    Proceed to
    P0657
    A
    No output
    B



B
CHECK FOR INTERMITTENT PROBLEMS (Click here)
A

REPLACE HYBRID VEHICLE CONTROL ECU (Click here)