Home › ENGINE › 3MZ-FE EMISSION CONTROL › FUEL TANK PRESSURE SENSOR

FUEL TANK PRESSURE SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL VAPOR PRESSURE SENSOR ASSEMBLY


    A176006E01
  1. Install the vapor pressure sensor assembly with the tube joint clip.

    NOTICE:
    1. Check that there are no scratches or foreign objects on the connecting part.
    2. Check that the vapor pressure sensor assembly is inserted securely.
    3. Check that the tube joint clip is on the collar of the vapor pressure sensor assembly.
    4. After installing the tube joint clip, check that the fuel tube joint is not pulled off.



    A176004
  1. Connect the connector.



2. INSTALL FUEL TANK ASSEMBLY
(Click here)