Home › BODY › ENGINE HOOD / DOOR › FUEL LID OPENER SYSTEM

FUEL LID OPENER SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
By reading the Data List displayed on an the Techstream, you can check values, including those of the switches, sensors, and actuators, without removing any parts. Reading the Data List as the first step in troubleshooting is one method of shortening diagnostic time.

NOTICE:
In the table below, the values listed under Normal Condition are reference only. Do not depend solely on these values when determining whether or not a part is faulty.

  1. Put the vehicle in inspection mode (Click here).

  2. Warm up the engine.

  3. Turn the power switch off.

  4. Connect the Techstream to the DLC3.

  5. Turn the power switch on (IG).

  6. Turn the Techstream on.

  7. Enter the following menus: Powertrain / Engine and ECT / Data List.

  8. Read the Data List according to the display on the Techstream.

    Engine and ECT (Hybrid Vehicle Control ECU): 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Fuel Lid
    Fuel lid courtesy switch status: OPEN or CLOSE
    OPEN: Fuel lid opened
    CLOSE: Fuel lid closed
    -
    Fuel Lid Switch
    Fuel lid opener switch status: ON or OFF
    ON: Fuel lid opener switch is pushed
    OFF: Fuel lid opener switch is not pushed
    -
    Fuel Filler Opener
    Fuel lid opener motor actuating status: ON or OFF
    ON: Fuel lid opener motor is actuated
    OFF: Fuel lid opener motor is not actuated
    -


ACTIVE TEST

HINT:
Performing an Active Test enables components including the relays, VSV (Vacuum Switching Valve) and actuators, to be operated without removing any parts. An Active Test can be performed with the Techstream. Performing an Active Test as the first step in troubleshooting is one method of shortening diagnostic time.

  1. Data List can be displayed during an Active Test.
  1. Put the engine in inspection mode (Click here).

  2. Connect the Techstream to the DLC3.

  3. Turn the power switch on (IG).

  4. Turn the Techstream on.

  5. Enter the following menus: Powertrain / Engine and ECT / Active Test.

  6. Perform the Active Test according to the display on the Techstream.

    Engine and ECT (Hybrid Vehicle Control ECU): 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Activate Fuel Filler Opener
    Operate fuel lid opener motor
    ON / OFF
    Confirm that engine is stopped