DTC P0ADB-227 Hybrid Battery Positive Contactor Circuit Stuck Open |
DTC P0ADC-226 Hybrid Battery Positive Contactor Circuit Stuck Closed |
| DTC No. | INF Code | DTC Detection Condition | Trouble Area |
| P0ADB | 227 | GND short in SMR2 (CON2) circuit |
|
| P0ADC | 226 | Open or +B short in SMR2 (CON2) circuit |
| 1.CHECK HARNESS AND CONNECTOR (HYBRID VEHICLE CONTROL ECU - HV RELAY ASSEMBLY) |
Turn the power switch off.
Remove the service plug grip (Click here).
Disconnect connector D36 from the hybrid vehicle control ECU.
Disconnect connector z20 from the HV relay assembly.
Turn the power switch on (IG).
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D36-2 (CON2) - Body ground | Power switch on (IG) | Below 1 V |
Turn the power switch off.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D36-2 (CON2) - z20-1 (CON2) | Power switch off | Below 1 Ω |
| Tester Connection | Switch Condition | Specified Condition |
| D36-2 (CON2) or z20-1 (CON2) - Body ground and other terminals | Power switch off | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.CHECK HV RELAY ASSEMBLY (SMR2) |
Turn the power switch off.
Remove the service plug grip (Click here).
Remove the HV relay assembly from the vehicle (Click here).
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| z30-1 - j2-1 | Auxiliary battery voltage is applied between terminals z20-1 (CON2) and z20-4 (GND) | Below 1 Ω |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| z20-1 (CON2) - z20-4 (GND) | -31 to 176°F (-35 to 80°C) | 20 to 60 Ω |
|
| ||||
| OK | ||
| ||