Home › HYBRID SYSTEM · P310 › HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P3110-139    IGCT Relay Malfunction

DTC    P3110-223    IGCT Relay Malfunction

for Preparation Click here


DESCRIPTION

The hybrid vehicle control ECU monitors the IGCT relay and detects the following malfunction.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P3110
139
Relay activation IC error
  1. Wire harness or connector
  2. IGCT relay
  3. Hybrid vehicle control ECU
223
IGCT relay remains stuck closed.

WIRING DIAGRAM


A198791E01


INSPECTION PROCEDURE

HINT:
If auxiliary battery voltage is applied to terminal +B1, +B2, or MREL of the hybrid vehicle control ECU, even though the power switch is off, the circuit is shorted to +B.

1.CHECK IGCT RELAY
  1. Remove the IGCT relay from the engine room relay block.



    A032779
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Auxiliary battery voltage is not applied between terminals 1 and 2
    10 kΩ or more
    3 - 5
    Auxiliary battery voltage is applied between terminals 1 and 2
    Below 1 Ω



NG
REPLACE IGCT RELAY
OK


2.CHECK HARNESS AND CONNECTOR (HYBRID VEHICLE CONTROL ECU - IGCT RELAY)
  1. Disconnect connector A43 from the hybrid vehicle control ECU.

  1. Turn the power switch on (IG).



    A201275E01
  1. Measure the voltage according to the value(s) in the table below .

    NOTICE:
    Turning the power switch on (IG) with the hybrid vehicle control ECU connectors disconnected causes other DTCs to be stored. Clear the DTCs after performing this inspection.

    Standard voltage:
    Tester Connection
    Specified Condition
    A43-12 (MREL) - Body ground
    Below 1 V
    A43-2 (+B1) - Body ground
    Below 1 V
    A43-1 (+B2) - Body ground
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE HYBRID VEHICLE CONTROL ECU (Click here)