REAR DOOR LOCK > REMOVAL |
| 1. DISCONNECT NEGATIVE BATTERY TERMINAL |
| 2. REMOVE REAR DOOR INSIDE HANDLE BEZEL |
![]() |
Using a screwdriver with the tip wrapped with protective tape, disengage the 3 claws and remove the rear door inside handle bezel plug.
| 3. REMOVE REAR DOOR ARMREST UPPER BASE PANEL |
![]() |
Using a screwdriver with the tip wrapped with protective tape, disengage the 6 claws and 2 clips, and remove the rear door armrest upper base panel.
Disconnect the connector.
| 4. REMOVE DOOR ASSIST GRIP COVER |
![]() |
Using a screwdriver with the tip wrapped with protective tape, disengage the 4 claws and remove the door assist grip cover.
| 5. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY |
![]() |
Remove the 3 screws.
![]() |
Using a clip remover, disengage the 9 clips.
Disengage the 5 claws and separate the rear door trim board sub-assembly from the rear door inner glass weatherstrip.
![]() |
Disengage the 2 clamps.
Disconnect the front door lock remote control cable and rear door inside locking cable.
| 6. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP |
![]() |
Remove the rear door inner glass weatherstrip from the rear door panel.
| 7. REMOVE REAR DOOR SERVICE HOLE COVER |
![]() |
Disconnect the connector.
Remove the rear door service hole cover.
| 8. REMOVE REAR DOOR WEATHERSTRIP |
![]() |
Using a clip remover, disengage the 19 clips and remove the rear door weatherstrip.
| 9. REMOVE REAR DOOR GLASS RUN |
![]() |
Remove the rear door glass run.
| 10. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY |
![]() |
Remove the rear door vent seal.
![]() |
Remove the 2 bolts, screw, and the rear door window division bar sub-assembly.
| 11. REMOVE REAR DOOR QUARTER WINDOW GLASS |
![]() |
Remove the rear door quarter window glass and the rear door quarter window weatherstrip as a unit as shown in the illustration.
Remove the rear door quarter window glass from the rear door quarter window weatherstrip.
| 12. REMOVE REAR DOOR GLASS SUB-ASSEMBLY |
![]() |
Remove the rear door glass sub-assembly from the rear door window regulator sub-assembly as shown in the illustration.
| 13. REMOVE REAR DOOR LOCK ASSEMBLY |
![]() |
Using a "TORX" socket wrench (T30), remove the 3 screws.
Move the rear door lock assembly downward and pull the release plate out of the rear door outside handle frame.
Remove the door lock wiring harness seal from the rear door lock assembly.
| 14. REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY |
![]() |
Using a screwdriver, disengage the claw.
![]() |
Remove the rear door lock remote control cable assembly.
| 15. REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY |
![]() |
Using a screwdriver, disengage the 3 claws.
![]() |
Remove the rear door inside locking cable assembly.