Home › ENGINE › 3MZ-FE ENGINE CONTROL SYSTEM › SFI SYSTEM

DTC    P060A    Internal Control Module Monitoring Processor Performance

for Preparation Click here


DESCRIPTION

The main CPU and sub CPU of the ECM (included in the hybrid vehicle control ECU) perform data communication between each other. The main CPU monitors the communications and WDC pulses from the sub CPU. When the signal malfunctions below are detected, a DTC is output.

DTC No.
DTC Detection Condition
Trouble Area
P060A
When either condition below is met:
  1. Hybrid vehicle control ECU main CPU error
  2. Hybrid vehicle control ECU sub CPU error
  3. Electronic throttle monitoring CPU error
Hybrid vehicle control ECU

MONITOR STRATEGY


Related DTCs
None
Required sensors / components (main)
Hhybrid vehicle control ECU
Required sensors / components (related)
-
Frequency of operation
Continuous
Duration
Within 1 second
MIL operation
Immediate
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


Monitor runs whenever following DTCs are not present
None
CPU reset
Occurred

TYPICAL MALFUNCTION THRESHOLDS


When either condition below is met:
Condition 1 or 2
1. When all conditions below are met:
-
- CPU reset
1 time or more
- Learned throttle position
2.6 V or more
- Electronic throttle actuator
OFF
2. CPU reset
2 times or more

INSPECTION PROCEDURE

1.CHECK DTC
  1. Clear the DTCs (Click here).

  1. Turn the power switch off.

  1. Disconnect the cable from the negative auxiliary battery terminal and wait for 1 minute.

  1. Connect the cable to the negative auxiliary battery terminal.

  1. Turn the power switch on (IG).

  1. Check for DTCs.

    OK:
    P060A is not present.



NG
REPLACE HYBRID VEHICLE CONTROL ECU (Click here)
OK

CHECK FOR INTERMITTENT PROBLEMS (Click here)