Home › ENGINE › 3MZ-FE ENGINE CONTROL SYSTEM › SFI SYSTEM

DTC    P060E    Internal Control Module Throttle Position Performance

for Preparation Click here


DESCRIPTION

The ECM (included in the hybrid vehicle control ECU) monitors the input signals of the throttle position sensor No. 1. As the ECM monitors the input signals of the throttle position sensor No. 1, if the input signals deviated, a DTC is output.

DTC No.
DTC Detection Condition
Trouble Area
P060E
When either condition below is met:
  1. Hybrid vehicle control ECU main CPU error
  2. Hybrid vehicle control ECU sub CPU error
Hybrid Vehicle Control ECU

MONITOR STRATEGY


Related DTCs
None
Required sensors / components (main)
Hybrid vehicle control ECU
Required sensors / components (related)
-
Frequency of operation
Continuous
Duration
1 second
MIL operation
Immediate
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


Monitor runs whenever following DTCs are not present
None
DMA communication error
Not detected

TYPICAL MALFUNCTION THRESHOLDS


When one of following conditions is met:
Condition 1 or 2
1. Difference of main TP and sub TP
0.3 V or more
2. Difference of main brake switch signal and sub brake switch signal
Different

INSPECTION PROCEDURE

1.CHECK DTC
  1. Clear the DTCs (Click here).

  1. Turn the power switch off.

  1. Disconnect the cable from the negative battery terminal and wait for 1 minute.

  1. Connect the cable to the negative battery terminal.

  1. Turn the power switch on (IG).

  1. Check for DTCs.

    OK:
    P060E is not present.



NG
REPLACE HYBRID VEHICLE CONTROL ECU (Click here)
OK

CHECK FOR INTERMITTENT PROBLEMS (Click here)