Home › ENGINE › 3MZ-FE ENGINE CONTROL SYSTEM › SFI SYSTEM

DTC    P0606    ECM / PCM Processor

for Preparation Click here


MONITOR DESCRIPTION

The ECM (included in the hybrid vehicle control ECU) continuously monitors its main and sub CPUs. This self-check ensures that the ECM is functioning properly. If outputs from the CPUs are different and deviate from the standards, the ECM will illuminate the MIL and set the DTC immediately.

DTC No.
DTC Detection Condition
Trouble Area
P0606
Hybrid vehicle control ECU main CPU error
Hybrid vehicle control ECU

MONITOR STRATEGY


Related DTC
P0606: ECM range check
Required Sensors/Components (Main)
ECM
Required Sensors/Components (Related)
-
Frequency of Operation
Continuous
Duration
Within 1 second
MIL Operation
Immediate
Sequence of Operation
None

TYPICAL ENABLING CONDITIONS


Monitor runs whenever the following DTCs are not present
None

TYPICAL MALFUNCTION THRESHOLDS


CPU reset
Occurred

INSPECTION PROCEDURE

1.READ OUTPUT DTC (DTC P0606)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the Techstream on.

  1. Clear the DTCs (Click here).

  1. Turn the power switch off and turn the Techstream off.

  1. Disconnect the Techstream.

  1. Disconnect the cable from the auxiliary battery negative (-) terminal and wait for 1 minute.

  1. Connect the cable to the auxiliary battery negative (-) terminal.

  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the Techstream on.

  1. Select the following menu items: Powertrain / Engine and ECT / Trouble Codes.

  1. Read the DTCs.

    Result:
    Result
    Proceed to
    No output
    A
    P0606
    B



B
REPLACE HYBRID VEHICLE CONTROL ECU (Click here)
A

CHECK FOR INTERMITTENT PROBLEMS (Click here)