Home › HYBRID SYSTEM · P310 › HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

HYBRID CONTROL SYSTEM > Pattern Select Switch Circuit

for Preparation Click here


DESCRIPTION

If pattern select switch signals are input to the hybrid vehicle control ECU, the ECU sends signals to the combination meter assembly via CAN communication to turn on the ECON mode light.

A175887E04


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM (BUS CHECK)

HINT:
ECUs that are correctly connected to the CAN communication system can be displayed on Techstream.

  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Select the following menu items: System Select / CAN Bus Check.

    Result:

    Result
    Proceed to
    All of the ECUs and sensors that are currently connected to the CAN communication system are displayed.
    A
    None of the ECUs and sensors that are currently connected to the CAN communication system are displayed, or some of them are not displayed.
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2.CHECK DTC OUTPUT (ALL DTC CODE)
  1. Check for DTCs of all systems by following the prompts on the tester screen.

    Result:
    Result
    Proceed to
    No DTCs are output.
    A
    DTCs other than hybrid control system DTCs are output.
    B



B
GO TO DTC CHART
A


3.PERFORM ACTIVE TEST USING TECHSTREAM (METER)
  1. Select the following menu items: Body Electrical / Combination Meter / Active Test / Indicat. ECO.

  1. Check the condition of the pattern select indicator light (ECON mode light) by operating the tester.

    OK: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Indicat. ECO
    Pattern select indicator light (ECON mode light)
    ON or OFF
    -

    Result:
    Result
    Proceed to
    The ECON mode light comes on.
    A
    The ECON mode light does not come on.
    B



B
GO TO METER SYSTEM (Click here)
A


4.CHECK PATTERN SELECT SWITCH ASSEMBLY (ECON MODE SWITCH)
  1. Turn the power switch off.

  1. Disconnect the pattern select switch assembly (ECON mode switch) connector.



    A175981E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    9 (2ND) - 6 (E)
    ECON mode switch on
    Below 1 Ω
    9 (2ND) - 6 (E)
    ECON mode switch off
    10 kΩ or higher



NG
REPLACE PATTERN SELECT SWITCH ASSEMBLY (ECON MODE SWITCH)
OK


5.CHECK HARNESS AND CONNECTOR (HYBRID VEHICLE CONTROL ECU - BODY GROUND)
  1. Connect the pattern select switch assembly connector.

  1. Disconnect connector D36 from the hybrid vehicle control ECU.



    A174445E04
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    D36-9 (SNWI) - Body ground
    ECON mode switch on
    Below 1 Ω
    D36-9 (SNWI) - Body ground
    ECON mode switch off
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE HYBRID VEHICLE CONTROL ECU (Click here)