Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL MAIN SWITCH

CRUISE CONTROL MAIN SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent airbag deployment (Click here).

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE LOWER NO. 3 STEERING WHEEL COVER


    C165090
  1. Disengage the claw and remove the lower No. 3 steering wheel cover.



3. REMOVE LOWER NO. 2 STEERING WHEEL COVER


    C178264
  1. Disengage the claw and remove the lower No. 2 steering wheel cover.



4. REMOVE STEERING PAD


    C166981E01
  1. Using a "TORX" socket wrench (T30), loosen the 2 "TORX" screws until the groove along the screw circumference catches on the screw case.



    C165092
  1. Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand as shown in the illustration.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.



    C165094E01
  1. Disconnect the horn connector from the steering pad.

  1. Using a screwdriver with the tip wrapped with protective tape, disconnect the 2 airbag connectors and remove the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



5. REMOVE CRUISE CONTROL MAIN SWITCH


    E150160
  1. Remove the 2 screws.

  1. Disconnect the connector.



    E150161
  1. Remove the cruise control main switch as shown in the illustration.