Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT DIMMER SWITCH

HEADLIGHT DIMMER SWITCH > REMOVAL

for Preparation Click here



1. POSITION FRONT WHEELS STRAIGHT AHEAD


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent airbag deployment (Click here).

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE LOWER NO. 3 STEERING WHEEL COVER


    C165090
  1. Disengage the claw and remove the lower No. 3 steering wheel cover.



4. REMOVE LOWER NO. 2 STEERING WHEEL COVER


    C178264
  1. Disengage the claw and remove the lower No. 2 steering wheel cover.



5. REMOVE STEERING PAD


    C166981E01
  1. Using a "TORX" socket wrench (T30), loosen the 2 "TORX" screws until the groove along the screw circumference catches on the screw case.



    C165092
  1. Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand as shown in the illustration.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.



    C165094E01
  1. Disconnect the horn connector from the steering pad.

  1. Using a screwdriver with the tip wrapped with protective tape, disconnect the 2 airbag connectors and remove the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



6. REMOVE STEERING WHEEL ASSEMBLY


    C165708E01
  1. Align the matchmarks on the steering wheel assembly and steering main shaft.

  1. Install the steering wheel assembly set nut.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }

  1. Connect the connectors to the spiral cable sub-assembly.



7. REMOVE STEERING COLUMN COVER


    C165715
  1. Remove the 2 screws.



    C166128
  1. Disengage the 2 claws to remove the lower steering column cover.



    C165716
  1. Disengage the claw to remove the upper steering column cover.



8. REMOVE SPIRAL CABLE WITH STEERING ANGLE SENSOR


    C165095
  1. Disconnect the connectors from the spiral cable with steering angle sensor.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Disengage the 3 claws and remove the spiral cable with steering angle sensor.



9. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY


    E151096
  1. Disconnect the 2 connectors.

  1. Disengage the claw and remove the windshield wiper switch assembly.

    NOTICE:
    If the claw is pushed with excessive force, it may break.



10. REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY


    E150079
  1. Disconnect the connector.

  1. Disengage the clamp as shown in the illustration.



    E146403
  1. Disengage the claw and remove the headlight dimmer switch assembly as shown in the illustration.