Make sure to select DEF mode before disconnecting the cable from the negative (-) battery terminal (for RHD).
1. PRECAUTION
2. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
3.REMOVE FRONT WHEEL
45130
4.REMOVE HORN BUTTON ASSEMBLY
45100
5.REMOVE STEERING WHEEL ASSEMBLY
45287
6.REMOVE LOWER STEERING COLUMN COVER
Remove the 2 screws.
Disengage the 2 claws.
Disengage the claw and remove the lower steering column cover.
45286B
7.REMOVE UPPER STEERING COLUMN COVER
Disengage the 6 clips from the upper steering column cover.
Disengage the 2 claws and remove the upper steering column cover.
8.REMOVE TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY
Do not replace the spiral cable with sensor sub-assembly with the battery connected and the ignition switch ON.
Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly with the battery connected and the ignition switch ON.
Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.
Disconnect each connector from the turn signal switch assembly with spiral cable sub-assembly.
Disengage the 3 claws to remove the turn signal switch assembly with spiral cable sub-assembly from the steering column assembly.
73900
9.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
45220
10.SEPARATE STEERING INTERMEDIATE SHAFT ASSEMBLY
Loosen the bolt.
| *a | Matchmark |
Put matchmarks on the steering intermediate shaft assembly and the steering link assembly.
Remove the bolt and separate the steering intermediate shaft assembly from the steering link assembly.
87201L
11.REMOVE NO. 4 AIR DUCT SUB-ASSEMBLY (for LHD)
Remove the bolt.
Disengage the 2 claws and guide to remove the No. 4 air duct sub-assembly.
87201F
12.REMOVE NO. 3 AIR DUCT SUB-ASSEMBLY (for RHD)
Disengage the 2 claws and guide to remove the No. 3 air duct sub-assembly.
47110
13.REMOVE BRAKE PEDAL SUPPORT ASSEMBLY
for LHD: Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE PEDAL(for LHD)>REMOVAL
for RHD: Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE PEDAL(for RHD)>REMOVAL
14.REMOVE STEERING POST ASSEMBLY
Disconnect each connector and disengage each wire harness clamp from the steering post assembly.
Remove the bolt to separate the ground wire.
Disengage the 2 clamps.
Disconnect the 2 connectors.
Remove the bolt, 2 nuts and steering post assembly.