| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Note |
|---|---|---|---|---|---|
| C1521 | Short in Motor Circuit | Motor overcurrent | Power steering ECU assembly | EPS warning light: Comes on | - |
| C1531 | ECU Malfunction | ECU internal malfunction
(CPU malfunction) |
Power steering ECU assembly | EPS warning light: Comes on | - |
| C1532 | ECU Malfunction | ECU internal malfunction
(Peripheral circuit malfunction) |
Power steering ECU assembly | EPS warning light: Comes on | - |
| C1533 | Temperature Sensor Circuit is Low or High | ECU internal malfunction
(Substrate temperature sensor malfunction) |
Power steering ECU assembly | EPS warning light: Does not come on | - |
| C1534 | EEPROM | ECU internal malfunction
(EEPROM error) |
Power steering ECU assembly | EPS warning light: Torque and motor rotation angle sensor adjustment is set to the default value and control is continued. In this case, the warning light illuminates. | - |
If the power steering ECU assembly has been replaced, perform assist map writing.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION
Clear the DTCs.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR
Check for DTCs.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTCs other than C1521, C1531, C1532, C1533 or C1534 are not output. | A |
| DTCs other than C1521, C1531, C1532, C1533 or C1534 are output. | B |
A
B