51441
1.REMOVE NO. 1 ENGINE UNDER COVER
51442
2.REMOVE NO. 2 ENGINE UNDER COVER
58166
3.REMOVE FRONT FLOOR COVER LH
|
Bolt |
|
Screw |
Remove the clip (A), 2 screws and 4 bolts from the front floor cover LH.
Disconnect the 2 clips (B) to remove the front floor cover LH.
17410
4.REMOVE FRONT EXHAUST PIPE ASSEMBLY
Remove the 4 bolts, 2 compression springs and front exhaust pipe assembly from the exhaust manifold converter sub-assembly (TWC: Front Catalyst) and center exhaust pipe assembly (TWC: Rear Catalyst).
Remove the 2 gaskets from the exhaust manifold converter sub-assembly (TWC: Front Catalyst) and front exhaust pipe assembly.
17118
5.REMOVE MANIFOLD STAY
Remove the bolt, nut and manifold stay from the exhaust manifold converter sub-assembly (TWC: Front Catalyst) and stiffening crankcase assembly.
17139
6.REMOVE NO. 2 MANIFOLD STAY
Remove the bolt, nut and No. 2 manifold stay from the exhaust manifold converter sub-assembly (TWC: Front Catalyst) and stiffening crankcase assembly.
17167
7.REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR
Remove the 4 bolts and No. 1 exhaust manifold heat insulator from the exhaust manifold converter sub-assembly (TWC: Front Catalyst).
89467B
8.REMOVE AIR FUEL RATIO SENSOR
25051
9.REMOVE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY (TWC: Front Catalyst)
Remove the 5 nuts and exhaust manifold converter sub-assembly (TWC: Front Catalyst) from the cylinder head sub-assembly.
Remove the exhaust manifold to head gasket from the cylinder head sub-assembly.
17168
10.REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR
Remove the 2 bolts and No. 2 exhaust manifold heat insulator from the exhaust manifold converter sub-assembly (TWC: Front Catalyst).
25586
11.REMOVE NO. 1 MANIFOLD CONVERTER INSULATOR
Remove the 4 bolts and No. 1 manifold converter insulator from the exhaust manifold converter sub-assembly (TWC: Front Catalyst).