Home › Engine / Hybrid System › 2GR-FE LUBRICATION › ENGINE OIL COOLER › 2013.12–2016.11
RM3160E _51 Engine / Hybrid System _019668 2GR-FE LUBRICATION _0105665 ENGINE OIL COOLER A

2GR-FE LUBRICATION  ENGINE OIL COOLER  INSTALLATION  


PROCEDURE

Hide 15710 1.INSTALL OIL COOLER ASSEMBLY

a.

Clean the installation surfaces of the oil cooler assembly.


b.

Install a new O-ring to the oil cooler assembly.


c.

Apply a small amount of engine oil to the oil cooler union bolt.


d.

Install the oil cooler assembly with the oil cooler union bolt.

Torque:
68 N*m (693 kgf*cm, 50 ft.*lbf)


e.

Install the No. 4 water by-pass hose and No. 5 water by-pass hose and slide the 4 clips to secure them.


f.

Engage the 2 clamps to install the 2 hose clamps.


g.

Install the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 17105 2.INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY LH

Hide 5.INSPECT FOR COOLANT LEAK