1.REMOVE ROOF HEADLINING ASSEMBLY
63218G
2.REMOVE SLIDING ROOF SIDE GARNISH LH
Disengage the 2 claws to remove the sliding roof side garnish LH.
63217G
3.REMOVE SLIDING ROOF SIDE GARNISH RH
Use the same procedure as for the LH side.
63201G
4.REMOVE SLIDING ROOF GLASS SUB-ASSEMBLY
Using a T25 "TORX" socket wrench, remove the 4 screws and sliding roof glass sub-assembly.
To prevent the sliding roof glass sub-assembly and sliding roof drive gear sub-assembly from being displaced, fully close the sliding roof glass sub-assembly (sliding roof drive cable sub-assembly), and then remove the sliding roof glass sub-assembly.
63251H
5.REMOVE SLIDING ROOF WEATHERSTRIP
Remove the sliding roof weatherstrip from the sliding roof panel sub-assembly.
6. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
7.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
8.DISCONNECT SLIDING ROOF DRAIN HOSE
for Clamp Type:
Disengage the claw and disconnect the sliding roof drain hose.
Use the same procedure for the other 3 sliding roof drain hoses.
for Clip Type:
Expand the clip and disconnect the sliding roof drain hose.
Use the same procedure for the other 3 sliding roof drain hoses.
62972C
9.REMOVE NO. 1 ROOF SIDE AIR DUCT LH
62971B
10.REMOVE NO. 1 ROOF SIDE AIR DUCT RH
Use the same procedure as for the LH side.
62180A
11.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH
62170A
12.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY RH
Use the same procedure as for the LH side.
86291
13.REMOVE TELEVISION BRACKET (w/ Rear Seat Entertainment System)
Remove the 4 bolts.
Disengage the clip and 2 guides to remove the television bracket.
14.REMOVE SLIDING ROOF HOUSING ASSEMBLY
Remove the 8 bolts, 8 nuts and sliding roof housing assembly.