Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on Front Door Windows)
RM3160E _59 Vehicle Exterior _019717 WINDOW / GLASS _0106114 POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on Front Door Windows) C

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on Front Door Windows)  B2313  Glass Position Initialization Incomplete  


DESCRIPTION

The power window regulator motor assemblies are operated by the power window regulator master switch assembly or power window regulator switch assembly. The power window regulator motor assembly has motor, regulator and ECU functions.

When the ECU determines that the power window regulator motor assembly has not been initialized, DTC B2313 is stored.

D-Door Motor
DTC No. Detection Item DTC Detection Condition Trouble Area
B2313 Glass Position Initialization Incomplete
·

Power window regulator motor assembly (for driver door) not initialized

·

Power window regulator motor assembly (for driver door) is malfunctioning

·

Battery disconnected when ignition switch ON


·

Power window regulator motor assembly (for driver door) not initialized

·

Power window regulator motor assembly (for driver door)



P-Door Motor
DTC No. Detection Item DTC Detection Condition Trouble Area
B2313 Glass Position Initialization Incomplete
·

Power window regulator motor assembly (for front passenger door) not initialized

·

Power window regulator motor assembly (for front passenger door) is malfunctioning

·

Battery disconnected when ignition switch ON


·

Power window regulator motor assembly (for front passenger door) not initialized

·

Power window regulator motor assembly (for front passenger door)



CAUTION / NOTICE / HINT

NOTICE:
·

DTC B2313 is stored in each power window regulator motor assembly.

·

If the battery is disconnected while the ignition switch is ON, DTC B2313 is stored.

·

If the power window regulator motor assembly (for driver door) or power window regulator motor assembly (for front passenger door) has been replaced with a new one, initialize the power window control system.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on Front Door Windows)>INITIALIZATION



PROCEDURE

1.PERFORM INITIALIZATION (APPLICABLE LOCATION)
a.

Turn the ignition switch to ON.


b.

Initialize the power window regulator motor assembly.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on Front Door Windows)>INITIALIZATION

HINT:

Initialize the power window regulator motor assembly that has DTC B2313 stored in its ECU.



Result:
Proceed to
NEXT



NEXT

2.CHECK DTC OUTPUT
2.CHECK DTC OUTPUT
a.

Turn the ignition switch off.


b.

Wait for at least 10 seconds, and then turn the ignition switch to ON.


c.

Check for DTCs.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on Front Door Windows)>DTC CHECK / CLEAR

Body Electrical > D-Door Motor > Trouble Codes
50001 124
Body Electrical > P-Door Motor > Trouble Codes
50001 144
HINT:

Check for DTCs for the power window regulator motor assembly that has DTC B2313 stored in its ECU.


OK:

DTC B2313 is not output.



Result:
Result Proceed to
OK A
NG (Driver door power window) B
NG (Front passenger door power window)



A

END (POWER WINDOW CONTROL SYSTEM HAS NOT BEEN INITIALIZED)

B

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR DRIVER DOOR OR FRONT PASSENGER DOOR)