Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
67492A
3.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH
69284C
4.REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG
5.REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)
6.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)
81230N
7.REMOVE COURTESY LIGHT ASSEMBLY
67602
8.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
67832
9.REMOVE FRONT DOOR SERVICE HOLE COVER
68102
10.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY
11.REMOVE FRONT DOOR WINDOW REGULATOR ASSEMBLY
85720D
12.REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY
Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor assembly.