Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR(for Rear Door)
RM3160E _59 Vehicle Exterior _019717 WINDOW / GLASS _0106117 POWER WINDOW REGULATOR MOTOR(for Rear Door) A

WINDOW / GLASS  POWER WINDOW REGULATOR MOTOR(for Rear Door)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 85720E 1.INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY

NOTICE:

The regulator arm must be below the intermediate position when installing the power window regulator motor assembly.


a.

Using a T25 "TORX" socket wrench, install the power window regulator motor assembly with the 3 screws.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

HINT:

When replacing the power window regulator motor assembly, a new power window regulator motor assembly uses self-tapping screws to thread new installation holes when the self-tapping screws are installed.



Hide 2.INSTALL REAR DOOR WINDOW REGULATOR ASSEMBLY

Hide 68104 3.INSTALL REAR DOOR GLASS SUB-ASSEMBLY

Hide 67408E 4.INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY

Hide 67872 5.CONNECT REAR DOOR WEATHERSTRIP

a.
B361140

Connect the rear door weatherstrip as shown in the illustration.


Hide 68152C 6.INSTALL REAR DOOR GLASS RUN

Hide 67858B 7.INSTALL REAR DOOR PANEL PROTECTOR

Hide 67842E 8.INSTALL REAR DOOR SERVICE HOLE COVER

Hide 67604 9.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

Hide 67488C 10.INSTALL REAR DOOR REAR GUIDE SEAL

Hide 11.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL

Hide 69284D 12.INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

Hide 13.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 14. INITIALIZE POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on 4 Windows)

Hide 15.INSPECT POWER WINDOW OPERATION