Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
69284D
3.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG
4.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL
67488C
5.REMOVE REAR DOOR REAR GUIDE SEAL
67604
6.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
67842E
7.REMOVE REAR DOOR SERVICE HOLE COVER
67858B
8.REMOVE REAR DOOR PANEL PROTECTOR
68152C
9.REMOVE REAR DOOR GLASS RUN
67872
10.DISCONNECT REAR DOOR WEATHERSTRIP
Disconnect the rear door weatherstrip as shown in the illustration.
67408E
11.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY
68104
12.REMOVE REAR DOOR GLASS SUB-ASSEMBLY
13.REMOVE REAR DOOR WINDOW REGULATOR ASSEMBLY
85720E
14.REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY
Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor assembly.