Home › Engine / Hybrid System › 2GR-FE ENGINE CONTROL › THROTTLE BODY › 2013.12–2016.11
RM3160E _51 Engine / Hybrid System _019662 2GR-FE ENGINE CONTROL _0106864 THROTTLE BODY A

2GR-FE ENGINE CONTROL  THROTTLE BODY  REMOVAL  


PROCEDURE

Hide 11209 2.REMOVE V-BANK COVER SUB-ASSEMBLY

Hide 17705 3.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

a.
A315077

Disconnect the mass air flow meter sub-assembly connector and disengage the wire harness clamp.


b.
A315078

Slide the clip and disconnect the No. 2 ventilation hose from the No. 1 air cleaner hose.


c.

Disengage the vacuum hose clamp from the No. 1 air cleaner hose.


d.

Disconnect the air hose from the air cleaner cap sub-assembly.


e.

Disengage the 2 air cleaner cap clamps.


f.
A315116

Loosen the hose clamp and remove the air cleaner cap with air cleaner hose from the throttle body with motor assembly.


Hide 22030 4.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY

a.
A315112

Disconnect the throttle body with motor assembly connector and disengage the wire harness clamp.


b.
A135708C01
0.344,0.875 0.667,0.875 0.667,0.875 0.917,1.292 true 0.656,1.958 0.823,1.958 0.823,1.958 0.896,1.656 true 0.458,1.885 0.656,2.063 0.198,0.177 10 true *1 0.188,0.802 0.354,0.979 0.167,0.177 10 true *2
*1 No. 2 water by-pass hose
*2 No. 3 water by-pass hose


Slide the 2 clips and disconnect the No. 2 water by-pass hose and No. 3 water by-pass hose from the throttle body with motor assembly.


c.
A315079

Remove the 4 bolts, wire harness clamp bracket and throttle body with motor assembly from the intake air surge tank.

NOTICE:

If the throttle body with motor assembly has been struck or dropped, replace it.



Hide 22271 5.REMOVE THROTTLE BODY GASKET

a.
A133820

Remove the throttle body gasket from the intake air surge tank.